A few dollars of drains, homemade four-layer flowerpots, bloomed beautifully

Friends who like to cultivate flowers can use pvc drainage pipes to make their own multi-layer flowerpots, put them indoors, save space, clean and beautiful, raise flowers on each layer, and flower, when they bloom, waterfalls are very spectacular.

How to make it, we can buy a ready-made water pipe in the hardware store, try it yourself

The material used is a variable diameter direct joint of 160 to 110, a section of 110 tubes of about 7 centimeters, a variable diameter direct joint of 110 to 50, a section of 50 tubes.

We put the 50 tubes about half a meter or so and half of them were punched to make the flower pots breathable. We put a 110-50 connector on the tube.

, and then put a short tube of 110, and finally, into the 160 variable 110 connector,

In this way, a layer of flower pots is ready.

Can be directly inserted in the pot, layer by layer to plug in, the flower pot to raise the flower, flowering, open into a flower waterfall, if it is to raise the crab claw, with the same effect of grafting, layered It's all flowers.